Operation Manual

• Cinebar 21 7
Setup/wall mounting
Setup location
Cinebar 21
A location directly under the TV set is ideal. Hang the
Cinebar 21 either directly to the wall or place it on the
stand
햳
below the TV set.
Subwoofer
If possible, you should also place the subwoofer on the
fl oor close to the television. However, you can also set it
up in another location in the room as the listener’s ears
are unable to locate lower tones.
Operating the device in the corner of a room is not
recommended.
Location tips
• Select a stable, level base.
Please consider the following chapter when mounting
the device on the wall.
• Make sure that the environment is clean and free from
dust.
• Avoid placing the unit close to sources of heat or in
direct sunlight.
• Arrange the connector cables so that they do not pose
a trip hazard.
• Do not place any heavy objects on top of the cables or
the units.
Wall mounting
You will need the following material for wall mounting on
a solid stone wall:
• 2 x dowels (ø 8 mm)
• 2 x screws, 5 x 50 mm
(screw head = ø 10–12 mm)
Danger
Risk of damage and electrical shock!
Proceed with caution when mounting the
device on the wall and follow the instructions
provided below.
• Only skilfull persons may mount the Cinebar 21 on
the wall.
• The product may only be mounted on a suitable, solid
wall. Special dowels or brackets may be necessary for
walls with a lightweight construction. Consult a profes-
sional.
• Make sure that no cables or pipes are located in the
areas where you are drilling. Use a metal detector to
check the areas before drilling.
1. Mark the hole distance between the two wall mounting
profi les of 61.25 cm on the wall where you intend to
install the Cinebar 21. Use a folding rule, pencil and
level for this purpose.
2. Use a metal detector to ensure that there are no cables
or pipes in the areas where you intend to drill. If neces-
sary, select another place for installation.
3. With an 8 mm masonry drill, drill a hole that is ap-
prox. 45 mm deep at each of the marked positions.
4. Insert 2 dowels (ø 8 mm) completely in the drill holes.
5. Screw one screw (5 x 50 mm) into each of the dowels
until the distance between the wall and screw head is
approx. 4 mm.
A
6. Push the Cinebar 21 up against the wall so that the
screws disappear into the holes A. Now pull the
Cinebar 21 down so that the screws slip into the nar-
row slot.
7. If necessary, turn the screws further into or out of the
holes until the Cinebar 21 is fi rmly mounted on the wall.