Operation Manual

Attention
Risk of damage!
Improper assembly may result in damage.
• If mounting the speakers on the wall, make sure that the
installation is carried out expertly.
• Before drilling the holes, make sure that no pipes are
located within the drilling area using a metal detector.
• Only use suitable screws and dowels to mount the speak-
ers. Verify the carrying capacity of the walls.
• Hang the center speak-
er up on the wall using
the keyhole openings
on the speaker back
side and the screws you
previously mounted.
• You can also use these
openings for mounting
a wall holder. You can nd suitable products for this in our
web shop.
Removing the protective grids
The protective grids are
attached by pins and
sockets on the front of
the speaker and can be
easily removed. When
the protective grids are
removed, high frequen-
cy output becomes clearer in particular.
To remove the protective grids, reach behind them and slowly
pull them off to the front.
Attention
Risk of damage!
Make sure that you do not touch the highly sensi-
tive diaphragms.
Connecting
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
1. Pull the power plug of your amplier/AV receiver out or multi-
channel active subwoofer of the outlet.
2. Lay the speaker cables from your amplier/AV receiver or
multi-channel active subwoofer to each speaker. These
cables should be high-quality double-wire speaker cable with
marked strands.
3. A connector comprising two terminals is located on the
back side of each speaker, to which you have to connect the
speaker cables.
The terminal clips are each marked red (+) and black (-).
Make sure the polarity is correct!
Connect the like coloured terminals. Otherwise the
sound quality will suffer.
The speaker connections of your
amplier/ AV receiver or
multi-channel active subwoofer should be marked similarly.
The strands of the speaker cables are marked with different
colours or shapes.
4. Split the single wire down to approx. 30 mm on both ends
and strip approx. 10 mm of insulation off of each cord.
5. Twist the stripped single wire ends together so that no wire
protrudes. Tin coating is not necessary.
6. Turn the connector terminal counterclockwise until loose.
Run the stripped cable end into the now visible hole. Close
the terminal by turning it clockwise. The cable has now been
clamped in place.
7. Connect the speaker cables to your amplier/AV receiver
or
multi-channel active subwoofer. The operating instructions of
the appliance should contain notes on this.
8. Reinsert the power plug of your amplier/AV receiver or
multi-channel active subwoofer into the outlet.
Crossover frequency
The ideal separation frequency for this speaker is 150 Hz. Set
this value on the amplier/AV receiver or DecoderStation.