Operating instructions

6 • Columa 200

Connecting

Danger

Danger of injury/damage!

Arrange the cables so that they do not pose a

trip hazard.

Satellite speakers

• Pull the mains plug of your AV receiver out of the

socket.

• Lay the speaker cables from your AV receiver to

each of the satellite speakers. This cable should be

high-quality double-wire speaker cable with marked

strands. The cross-section should amount to at least

1.5 mm

Tip: Label the cables on the receiver side. This will help

when taking down and setting up the receiver.

• A connector terminal with two terminal clips is located

on the back of each satellite speaker. Here you can

connect the speaker cables using pin plugs or directly.

We only describe the direct connection in these instruc-

tions.

• The terminals are each marked in red (+) and black (-).

Make sure the polarity is correct!

Connect the like coloured terminals with one

another. Otherwise the sound quality will suffer.

The speaker connectors of your AV receiver should be

marked similarly. The strands of the speaker cables are

marked with different colours or shapes.

• Split the single wire on both ends up to approx. 30 mm

and remove approx. 10 mm of the insulation on each

piece. Twist the single wire so that no strands are pro-

truding.

• Turn the connector terminal counterclockwise until

loose. Run the stripped cable into the hole that is now

visible. Turn the terminal clockwise until closed. The

cable has now been clamped in place.

• Connect all cables to the satellite speakers this way.

• Connect the speaker cable to your AV receiver. The

operating instructions of the appliance should contain

notes on this.

• Also plug the mains plug of your AV receiver back into

the socket.

• Set the crossover frequency between the satellite

speakers and subwoofers on the AV receiver to

120 Hz.

T 800 SW

91744 GB 20110110.indd 691744 GB 20110110.indd 6 11.01.11 16:0811.01.11 16:08