Operating instructions

8 • Concept C 300 WL
Setup and connection
Setup location
• Preferably, the room, where you plan to use a Con-
cept C 300 WL, should not be larger than 25 sqm.
• Select a stable, level base.
• Make sure that the environment is clean and free from
dust.
• Avoid placing the unit close to sources of heat or in
direct sunlight.
• Arrange the connecting cables so that they do not
pose a trip hazard.
• Do not place any heavy objects on top of the cables
or units.
Subwoofer
In general, you can position the subwoofer anywhere on
the fl oor in the room. Positioning the subwoofer between
the two front satellites is often benefi cial. However, it is
not absolutely necessary that it be situated between the
satellite speakers as our ears are not capable of directly
locating the source of bass tones.
There should be at least 30 cm of space in front of the
bass speaker 2 and the refl ex opening 3 as consider-
able air movement is produced around these openings at
higher volumes.
Satellite speakers
For the best possible sound quality, you should
• set up the left and right speaker at equal distances
from your preferred sitting position;
• set up the speakers at ear level;
• position the speakers on a shelf so that their front
panel is fl ush with the front edge of the shelf;
• do not cover the speakers with fabrics or objects.
You can set up the satellite speakers using the stands
included in the product contents or mount them directly
on the wall.
Table stand assembly
Insert the screw  through
the top hole of the table
stand  and turn the
screw into the threaded
bushing 10 on the back
of the speaker. Do not
over tighten the screw. The
connectors of the speaker
cord are now covered by
the table stand – to connect
them later on, loosen the
screw somewhat and turn
the table stand to the side.
Wall mounting
You will need the following materials for wall mounting:
• one screw for each speaker, 4 x 40 mm
(screw head = ø 9 mm)
• for rock walls, one dowel for each speaker (ø 5 mm)
Danger
Danger of damage and electric shock!
Proceed with care when mounting the unit on
the wall and follow the instructions below.
• The speakers may only be mounted on the wall by
properly qualifi ed persons.
• The unit may only be mounted on a suitable, solid wall.
If mounting on plasterboard walls special dowels or fi x-
ings may be required. Seek the advice of an expert.
• Ensure that no cords or pipes are located at the desired
mounting point. Before drilling and tightening the
screws, check the applicable areas with a metal detec-
tor.
Drive the screw into the wall and hang the speaker with
the mounting hole 9 on the screw.
Connecting the satellites
To connect the satellite speakers, use high-quality, two-
core speaker cable with a diameter of at least 1.5 mm
2
and if possible, a banana plug for the subwoofer. You
can order them both as a set in our webshop (www.
teufelaudio.com) in the “Accessories” area.
The connector terminals 6 “SPEAKER OUT” for the right
(“Right ”) and left (“Left ”) speakers are located on the
back of the subwoofer.
The connector terminals 11 are located on the back of
the satellite speakers.
The terminals are marked in red (+) and black (-) respec-
tively.

6
1111
91236 GB 20110601.indd 891236 GB 20110601.indd 8 01.06.11 16:2701.06.11 16:27