Technical description and operating instructions ControlStation 2 Control Unit for PC Speaker Systems
Contents General notes and information ......................................................................................................................................3 Proper use..................................................................................................................................................... 3 Safety notes ..................................................................................................................................................................
General notes and information Notice The information in this document may be changed without prior notice and in no way constitutes any liability on the part of Lautsprecher Teufel GmbH. No part of these instructions may be reproduced in any form or be broadcasted in any way electronically, mechanically, by photocopy or recording without the written permission of Lautsprecher Teufel GmbH. © Lautsprecher Teufel GmbH Version 1.
Safety notes Caution icons You will find the following caution icons used in these instructions: Danger High risk! Failure to observe the warning may result in severe personal injury or death Attention Moderate risk! Failure to observe the warning may result in property damage. Minor risk! Points which should be observed when handling the unit. Safety notes Danger Risk of electric shock! Faulty installation of electrical equipment or mains voltage which is too high can cause electric shocks.
Danger Danger of injury/damage! Incorrect location may result in damage. • Never use the unit unmounted in vehicles, in instable locations, on wobbly stands or furniture, with attachment fixtures that are too small etc. The unit could topple over or fall, injuring persons or causing damage to the unit itself. • Arrange the device so that it cannot be knocked over accidentally and make sure that the cables do not pose a trip hazard. • Do not place the unit near sources of heat (e. g.
Control elements and connections Front side 1 Pos Name 2 3 4 5 6 7 8 9 Standby Phones Mute + Source Mic Pure – Description Pos Name 1 Standby On/Standby button 2 Source Select an audio source 3 Phones Earphone connection 4 Mic 5 — Description 6 Mute Muting 7 Pure Switch between stereo (2.0) or 5.
Remote control Pos Name Description 18 Mute 24 18 Control the display panel brightness 23 20 21 Increase the volume 22 21 22 Reduce the volume 19 20 23 Aux 1, Aux 2, Select an audio source Aux 3 Dimmer Pure 19 Switch between stereo (2.0) or 5.1 upmix On/Standby button 24 Setup and connection Setup location • Select a stable, level base. • Make sure that the environment is clean and free from dust. • Avoid placing the unit close to sources of heat or in direct sunlight.
Remote control A 3-volt button cell, type CR2025, is used to power the remote control. Upon delivery, this button cell is already in the remote control and is secured by a plastic strip. The strip is visible on the back of the remote control. Just carefully pull it out. The remote control is now ready for use. Changing the batteries • Hold the remote control with the bottom facing up. • Press the bar on the A battery compartment to the middle (A) and pull out the compartment (B).
Selecting a source After turning the unit on, the last audio source is selected. • You can switch the source with the button 2 “Source” and/or the buttons 19 “Aux 1”, “Aux 2”, and “Aux 3”. The selected source is shown on the display panel 5. 2 5 7 Standby Phones Mute + Source Mic Pure – Pure mode The stereo signal of the sources Aux 2 and Aux 3 In is normally converted to a 5.1 signal (“Upmix”). With the button 7 “Pure” you can turn this conversion on or off.
Care and cleaning Clean your ControlStation 2 regularly with a soft, slightly damp microfibre cloth. Please note the following carefully: Attention Risk of damage! In contact with live parts, water can lead to electric shock or short circuit. • Ensure that no liquid penetrates the unit. • Pull the wall adapter out of the socket before cleaning. Attention Risk of damage! Using the wrong cleaning materials may damage the delicate surface of the case.
Technical data Power consumption, max: Operating voltage of the wall adapter: Operating voltage of the unit: 10 W 100–240 V~ / 50/60 Hz 12 V DC, 1 A Inputs: 1x 5.1 audio (RCA jacks) 2x stereo (RCA jacks) 1x microphone 3.5 mm mini jack Outputs: 1x 5.1 audio (RCA jacks) 1x headphones 3.5 mm mini jack 1x microphone 3.
For questions, suggestions or criticism please contact our customer service department: Lautsprecher Teufel GmbH Gewerbehof Buelowbogen - Aufgang D1 10783 Berlin (Germany), Buelowstr. 66 Tel.: +49 (0)30 - 300 930 0 Fax: +49 (0)30 - 300 930 930 www.teufel.eu No liability is accepted for the accuracy of this information. Technical changes, typographical errors and other errors reserved. Instruction No.