Operating instructions

• ControlStation 2 9

Selecting a source

After turning the unit on, the last audio source is selected.

You can switch the source with the button • 2 “Source”

and/or the buttons 19 “Aux 1”, “Aux 2”, and “Aux 3”.

The selected source is shown on the display panel 5.

Pure mode

The stereo signal of the sources Aux 2 and Aux 3 In is

normally converted to a 5.1 signal (“Upmix”). With the

button 7 “Pure” you can turn this conversion on or off.

Only the front channels right and left as well as the sub-

woofer channel are active in pure mode. The correspond-

ing source is shown on the display panel as “P2” and/or

“P3” instead of “A2” and/or “A3”.

5.0 mode

If your source device does not provide a subwoofer chan-

nel, you can switch from 5.1 mode to 5.0 mode with the

switch 16 “Sub”. Then the signal from the front channels

right and left will be mixed to the subwoofer channel.

Boosting the subwoofer

With this function, you can correct the drop-off of the

signal level at the subwoofer output, which occurs for sev-

eral 5.1 sources if the setting “Small” has been selected

for the satellites in bass management.

Slide the switch 15 “Sub” to the “+10dB” setting in order

to increase the volume of the subwoofer channel of the

AUX 1 input by approximately 10dB. The signal will be

issued to the subwoofer without any adjustment when the

switch is set to “0dB”.

Display field

You can adjust the brightness of the display panel from

bright to dark using the button 20 “Dimmer”.

16 15

PhonesStandby

Source Mic

+Mute

Pure –

25 7