Operating instructions
Connecting the AV receiver or PC
Center and satellite speakers
• Pull the power plug of your AV receiver out of the wall outlet.
• When connected to your PC, unplug the power cord of the
multi-channel active subwoofer from the wall outlet.
• Lay the speaker cables from your AV receiver/multi-channel
active subwoofer to each speaker. These cables should be
high-quality double-wire speaker cable with marked strands.
The cross section should amount to at least 0.75 mm².
• A connector comprising two terminals is located on the back
side of each speaker, to which you have
to connect the speaker cables.
• The terminal clips are colour coded (red
+ / black –)
Make sure the polarity is correct!
Connect the like coloured terminals. Otherwise, the
sound quality will suffer.
The speaker connections of your AV receiver or multi-channel
active subwoofer should be marked similarly. The strands of the
speaker cables are marked with different colours or shapes.
1. Split the single wire down to approx.
30 mm on both ends and strip approx.
10 mm of insulation off of each cord..
2. Twist the stripped single wire ends
together so that no wire protrudes. Tin
coating is not necessary.
3. Depress the terminal clips and run
the cable end into the corresponding
opening. Releasing the clips locks the
cable end in place.
4. Connect the cables to the other satel-
lite speakers in the same way.
5. Connect the speaker cables to your AV receiver or multi-
channel active subwoofer. The operating instructions of the
appliance should contain notes on this.
Crossover frequency
• The optimal crossover frequency for the CS 35 C Center
speaker is 150 Hz. To the extent possible, set your AV re-
ceiver or your Decoder Station to this value.
• If the satellite speakers are used in a Concept C set, the
crossover frequency is provided by the subwoofer. For the
Concept E sets you dene the crossover frequency via the
sound card settings. If you can not specify any settings there,
select at least the setting “small” for the satellite speakers.
Setup
• Place the center speaker on the
enclosed tabletop stand in a central
position directly under or on top of
the screen.
Wall mounting
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a trip
hazard.
Attention
Risk of damage!
Improper assembly may result in damage.
• If mounting the speakers on the wall, make sure that the
installation is carried out expertly.
• Only use suitable screws and dowels to mount the speakers.
Verify the carrying capacity of the walls.
• Suitable products (cables, stands and wall mounts) you can
nd in our web shop.
Note
Our website contains comprehensive notes for correct setup.
Aufstellen & Anschließen