Operation Manual
• DecoderStation 7 11
14
RC/Pre Out
You can configure the function of the analogue output 14
“RC/Pre Out” in the “System Setup” menu. (see “5.1/7.1”
on page 15):
5.1 operation Converts (via downmix) the 5.1 audio
signal on two stereo channels (2.0) in
order to, for example, project sound into a
second room.
7.1 operation Output of the additional rear channels
(REAR).
You can connect your power amplifier or multi-channel
active subwoofer, active speaker or a RF audio transmis-
sion system to these jacks. You will need a stereo RCA
cable to do so.
Headphones
You can connect stereo headphones with a 3.5 mm
phone plug to the “HEADPHONES” jack 13.
The outputs to the power amplifiers (14and 15) are
automatically deactivated when connecting headphones.
They can, however, be reactivated by pushing button 28
“
” on the remote control. This makes it possible to oper-
ate the DecoderStation 7 with the active speakers even
when headphones are inserted (e.g. while using wireless
headphones with transmitter permanently connected).
Danger
Danger of injury/damage!
Lower the volume before you pull out the head-
phone plug again; otherwise the speakers may
emit unexpected high sound pressure. This could injure
your hearing or damage the device.
Connecting to a power supply
• Make sure that your power amplifier, multi-channel ac-
tive subwoofer or the active speakers are turned off.
• Connect the small mains adapter c plug to the jack 19
“12V”.
• Connect the mains adapter c to a mains socket
(100 V–240 V ~ / 50/60 Hz).
13
19