Operation Manual

8 • DecoderStation 7
Setup
Location tips
• Select a stable, level base.
• Make sure that the environment is clean and free from
dust.
• Avoid placing the unit close to sources of heat or in
direct sunlight.
• Do not place any heavy objects on the Decoder-
Station 7 or the cables.
The receiver for signals from the remote control is located
at the front of the unit. You should therefore set up the unit
so that you can see it from your sitting position.
You will need two micro-type or AAA batteries with 1.5
Volt (included in the product contents) in order to operate
the remote control.
Inserting batteries
• Gently press down the arrow on the battery compart-
ment cover on the back of the remote control. Push the
cover down and out.
• If applicable, remove any old batteries (please observe
the disposal notes on page 20).
• Insert the batteries in the battery compartment as
shown in the figure.
• Place the cover back on the compartment and push it
closed.
Functionality
The remote control relays the control signals by means of
infrared light. For this, you will have to point the remote
control at the DecoderStation 7. The infrared receiver is
located on the front side. Make sure that the infrared light
is not obstructed by objects.
Remote control