Operating instructions

• Impaq® 3000 Mk 2 Blu-ray

Sensor buttons

The buttons on the front side of the receiver are sensor

buttons: Gently touching them is enough to trigger a

switch operation.

Activating and deactivating

• You can switch your receiver to operational mode or

standby mode with the button 15 or 69 “

”.

• The red LED 11 is on in standby mode.

Standby does not disconnect the device from the mains.

To turn it off completely, pull the power plug out of the

socket.

Selecting a source

After turning the device on, the last source device se-

lected is activated.

• You can change the source in this order with the button

2 “SRC”:

DISC (BD/DVD/CD and USB), HDMI 1, HDMI 2,

COAX IN, OPTI IN, AUX IN 1, AUX IN 2, AUX IN 3,

FM (radio USW), AM (radio MW).

• Or you can switch the source with the direct selection

buttons:

68 “AV Source” – DISC or USB, HDMI 1, HDMI 2

32 “Radio” – FM, AM

31 “Audio Source” – COAX IN, OPTI IN, AUX IN 1,

AUX IN 2, AUX IN 3

The selected source is shown in the display panel 13.

Adjusting the volume

• Increase the volume: Push the button 5 “Vol +” or the

button 40 “Volume +”.

• Decrease the volume: Push the button 5 “Vol –” or the

button 40 “Volume –”.

The selected volume is shown in the display panel 13 in

the range from 0 (low) to 40 (high).

Mute

• Turn off the sound with the button 39 “

”.

The notice “MUTE ON” will appear in the display

panel 13.

• Turn the sound back on: Push the button 39 “ ” again

or adjust the volume.

1113 25

Basic functions