Operating instructions

• Impaq® 3000 Mk 2 Blu-ray

Audio settings

You can access the audio settings by pushing the button

62 “Audio Setup”.

The menus appear on the display panel. There is there-

fore no need to activate the television set or the projector.

LEVEL – Adjust the volume of the individual speakers.

HDMI AUDIO OUT – Activate/deactivate sound transmis-

sion at the HDMI output.

TEST TONE – Adjust the volume of the individual speakers

with a test sound (noise).

LIPSYNC – Set the delay of the sound output.

SURROUND – Adjust the surround sound.

TONE – Adjust the sound.

DISTANCE – Set the signal travelling times of the speak-

ers.

Select the desired submenu with the navigation but-

tons 42 “▲” and 58 “▼” and push the select button 44

“Enter”.

After six seconds of keypad inactivity, the device will

return to normal mode.

LEVEL

Here you can increase or decrease the relative volume

for each speaker.

1. Select the desired speaker with the navigation buttons

42 “▲” and 58 “▼”:

FR – Front right

SW – Subwoofer

SL – Rear left

SR – Rear right

C – Center

FL – Front left

2. With the navigation buttons 59 “Ï” and 43 “Å”, set the

relative volume from “–10” to “+10”.

3. Finish by pushing the button 45 “Return”.

HDMI AUDIO OUT

You can switch sound transmission at the HDMI output 26

“HDMI OUT” on (“ON”) and off (“OFF”).

When you play movies, you do not need to mute the

television set in order to hear sound from the receiver

speakers.

TEST TONE

Adjusting the volume with a test tone. As described

above under “LEVEL”, you can increase or decrease the

relative volume for each speaker here. However, the

sound playback will be replaced by a test tone (noise).

The test tone is muted as soon as you leave the submenu.