Operating instructions

• Impaq® 3000 Mk 2 Blu-ray
27
56
58
59
62
67
42
43
44
46
the station is received in stereo, the note “STEREO” will
also appear.
Stations with a weak signal may cause faults in stereo
mode. In this case, switch to mono mode by pushing the
button 56 “Stereo/Mono”.
If the station transmits an RDS signal, the name of the
station is displayed shortly instead of the frequency. With
the button 46 “ RDS/Display”, you can access additional
RDS information if the radio station supports it.
Station memory
Your radio can save 20 stations for each of the two radio
frequency modes (FM and AM). You can conveniently
select the saved stations with the push of a button.
Saving the stations manually
• Set the desired station as described above.
• Push the button 1 “PRO” or 62 “Audio Setup/Program”.
The number of the fi rst free memory slot will appear in
the display panel.
• Select the desired memory slot number with the buttons
7 “
” and 6 “ ” or the number keys “1...0”.
• Push the button 1 “PRO” or 62 “Audio Setup/Program”
again.
The station has now been stored. The device will return to
normal operation after fi ve seconds of button inactivity.
Saving stations automatically
• Push the button 67 “Search/Auto Scan” for approx.
two seconds until station scanning starts.
The radio will now search for stations with a suffi cient
signal and save them automatically. Previously saved
stations are deleted in the process.
• If more than 20 stations have been found, the message
“FULL” will appear on the display panel and scanning
terminates.
Selecting stations from the memory
You can select the stations in the memory consecutively
with the buttons 42 “▲/Preset+” and 58 “▼/Preset–” or
directly with the number buttons.