Setup Guide Raumfeld Controller For a detailed online manual, visit http://manual.raumfeld.
Contents General Notes and Information............ 4 Integrating Your Music Collection........ 13 Overview............................................. 5 Frequently Asked Questions................ 14 System Requirements............................ 6 Advice on Safe Use & Maintenance..... 18 Connections & Operational Controls...... 7 Cleaning & Maintenance..................... 20 Operation Modes................................. 8 Environmental Protection.................... 21 Installation..........
General Notes and Information Notice 2. Serial number or batch number The information in this document may be changed without prior notice and in no way constitutes any liability on the part of Lautsprecher Teufel GmbH. No part of these instructions may be reproduced in any form or be broadcasted in any way electronically, mechanically, by photocopy or recording without the written permission of Lautsprecher Teufel GmbH. Visible on the back side of the device, e.g.
Übersicht Package Contents a a 1 x Raumfeld Controller b 1 x Raumfeld Charger 1 x Power adaptor DC 10V/ 2.5A 1 x Power cable • Please check if your shipment is complete and not damaged. • Should your shipment be incomplete or damaged, please contact our service department before use (see page 4).
System Requirements System requirements • For music playback: Raumfeld playback device RAUMFELD PLAYBACK DEVICE • For integration into your home network: Network router with DHCP • For wireless music playback: A Raumfeld Base OR Wi-Fi router (IEEE 802.11g) DHCP ROUTER OR RAUMFELD BASE WiFi-ROUTER Note: In case you have a Wi-Fi router, you do not need an additional network router. Please make sure, though, that your Wi-Fi router has DHCP enabled.
Connections and Operational Controls Controller 1 2 3 4 5 6 1 4 3 2 On/Off button Volume control Charge contacts Connector for power adaptor (DC 10V/2.5A Reset button USB port (master, type A) 1 5 6 ) 2 Charger 1 Charge contacts 2 Connector for power adaptor (DC 10V/2.
Operation Modes Overview 8 System mode Setting the mode Mode characteristics On Briefly press On/Off button Powersave System reverts automatically to powersave when inactive Display off, CPU throttled Sleep Mode System reverts automatically to sleep mode after a few minutes, or press On/Off button briefly Display, CPU, WLAN and touch panel off Off Press and hold On/Off button All modules off
Charging the Raumfeld Controller For charging, the Raumfeld Controller can be connected to the power supply in two alternative ways, either placed in the Raumfeld Charger, or directly connected to the power adaptor. To ensure that the battery indicator functions reliably, it is necessary to fully charge the battery once, while the Controller is turned on. A completely empty battery takes approximately 6 hours to charge. Charging via the Charger 1.
Setup: New Raumfeld System 1. Einrichtungsassistenten starten Turn on the Raumfeld Controller by briefly pressing the On/Off button. After a few seconds the Raumfeld setup screen will be displayed and the setup wizard will activate. ≥ In an unconfigured Raumfeld system the setup wizard will automatically be started as soon as the Controller is turned on. In order to access the setup wizard at a later stage choose “Settings > Reset > Controller Configuration”. 2.
Do you own a Raumfeld Base? In the beginning of the setup wizard you are asked if you own a Raumfeld Base. Please check carefully if your order contains a „Raumfeld Base“. The Base is an optional Raumfeld component which is recommended to be used as Wi-Fi access point in a multiroom setup. You can easily recognize the Base by its two antennas and three LEDs. In a system with Raumfeld Base your other Raumfeld devices will be connected to the Wi-Fi network provided by the Raumfeld Base.
Setup: Extending Your System Adding to an existing system If you already own an installed Raumfeld system and would like to add a further Controller, please follow the instructions below. 1. Turn on the Raumfeld Controller by briefly pressing the On/Off button. 2. After a few seconds the Raumfeld setup screen will be displayed and the setup wizard will activate. Please follow the path “Connect to existing system”.
Integrating Your Music Collection There are several possibilities for you to integrate your music collection into the Raumfeld system. Copying music onto the Raumfeld Base If you have a Raumfeld Base, you can save your music collection on the internal hard drive of the Base.
Frequently Asked Questions You can find a full list of frequently asked questions as well as a detailed online manual online at: http://manual.raumfeld.com. General questions Question 1: Where can I find internet radio? ≥ TuneIn offers you free access to a wide range of internet radio stations from all over the world. For radio stations which are tailored specifically to your own taste of music, try the music service Last.
Frequently Asked Questions fully check if your order contains a Raumfeld Base (also see page 11) and choose the appropriate path in the setup wizard. Problem solving Question 1: My Controller doesn‘t react. How can I reboot it? ≥ When the Controller no longer reacts to finger touch or turning the volume control: 1. 2. First switch off the device by pushing and holding the On/Off button for at least 10 seconds. Now, briefly press the On/Off button.
Frequently Asked Questions Question 3: My USB memory device is not recognised as a music resource. What could be the reason for this? ≥ USB memory devices are only included as a music resource if they are connected to the host of the Raumfeld system. In a system with a Raumfeld Base (see page 11), this is the Base. In a system without Raumfeld Base, you can specify the device you would like to act as host under “Settings > Network > Host configuration”.
Advice on Safe Use and Maintenance Warning icons The following symbols can be found in this guide: Danger High Risk! Disregard for this warning can cause life threatening damage. Attention Middle Risk! Disregard for this warning can cause damage to the product. Low Risk! Procedures that should be observed while handling the product. Advice on Safe Use Danger Electrical Shock Hazard! Faulty installation or high voltage may lead to electrical shock.
Advice on Safe Use and Maintenance Danger Child Safety! Children can get caught in the packaging materials and suffocate. • Never let your children play with the device or its packaging material. There is a risk of suffocation. • Make sure that your children do not remove or pull small pieces from the device (such as cables or buttons), as they may swallow the piece and choke. Should your child have swallowed a small piece of the device, immediately contact your local hospital.
Cleaning and Maintenance Clean the device regularly with a soft, lightly damp micro fiber cloth. Pay close attention to the following details: • Use as clear of a water as possible without any cleaning product. By stubborn spots use a mild combination of water and soap. 20 • Under no circumstances should harsh cleansers, alcohol, paint thinner, gasoline, or similar substances be used for cleaning.
Environmental Protection Disposal of the unit Used units must not be disposed with household waste! If the unit is no longer operational, every consumer is required by law to dispose of used devices separate from household waste, e. g. at a collection point run by the communal authority borough. In this way, used devices can be recycled and waste materials disposed of in an environmentally friendly manner. For this reason, electrical equipment is labelled with the displayed symbol.
? Do you have any questions or problems in setting up your Raumfeld system? Contact our customer service for help! Phone E-Mail 00800 - 200 300 40 (free of charge) raumfeld@teufelaudio.com Please have the following information ready: • • • Customer number Brand, model, and manual of your router LED status of your Raumfeld products All trademarks are the property of their respective owners.
