Operating instructions

8 • RearStation 4
Remote control
Connecting to a power supply
Transmitter
Connect the small plug of the mains adapter •
햸 with
the jack 4 “Power” of the transmitter 햲.
Insert the mains adapter • 햸 in a mains socket.
Receiver
Insert the small plug of the mains cable •
햷 in the mains
adapter jack 햶.
Insert the small plug of the mains adapter • 햶 in the
jack 12 of the receiver 햳.
Insert the mains plug of the mains cable • 햷 in a mains
socket.
4
12
햷
햳
햶
햵햴
햲햸
Changing the batteries
A 3-Volt button cell, type CR2025 is provided for the
operation of the remote control (included in the product
contents).
Hold the remote control • 햴 with the bottom up.
Push the bar on the battery compartment to the middle •
(A) and pull out the compartment (B).
If applicable, remove the old batteries (please observe •
the notes on page 12).
Place the new battery • 햵 in the bracket. In the proc-
ess, the “+” signs must be visible on the battery and on
the bracket.
Put the bracket back into the unit and push the com-•
partment until it locks into place.
Functionality
The remote control transmits infrared control signals.
For this, it is necessary that you point the remote control
towards the front of the device. Ensure that no objects are
in the way of the infrared signal.
Fluorescent lamps and energy/saving lamps installed
close nearby may affect the functions of the remote con-
trol or even prevent it from working.
A
B
91583 GB 20100825.indd 891583 GB 20100825.indd 8 25.08.2010 14:59:47 Uhr25.08.2010 14:59:47 Uhr