Operating instructions

• RearStation 4 9
Basic functions
Activating and deactivating
After you connected the mains adapters, the devices are
in standby mode.
Activation
Push the button • 15 “On” on the remote control.
Push the button • 2 “
” on the transmitter.
Push the volume button • 8 “ ” or
10 “ ” on the receiver.
Switching to standby
Push the button • 16 “Off” on the remote control.
Push the button • 2 “
” on the transmitter.
Push and hold the button • 9 “ ” on the receiver for
approx. four seconds.
Power LED
The power LEDs 3 and 11 are blue during normal opera-
tion. If there is no radio connection with the other device,
the power LEDs are red.
Adjusting the volume
Increasing the volume: Push the button • 18 “Volume +”
or button 10 “ ” respectively.
Reducing the volume: Push the button • 19 “Volume –” or
button 8 “ ” respectively.
Mute
Turning off the sound: Push the button • 17 or 9 “
”
respectively.
Turning the sound back on: Push the button • 17 or
9 “ ” respectively again or adjust the volume.
Settings
Impedance
By factory default, the amplifi er of the receiver is set to
match a speaker impedance of 4 ohm. If your speakers
have another Impedance, you can adjust the amplifi er as
follows:
Hold the remote control in front of the receiver.•
Push and hold the button • 17 “ ” for more than three
seconds.
The Power LED 11 alternately fl ashes blue and red now.
Within four seconds push one of the zone buttons • 20
“A B C”:
A – Impedance 4 ohm
B – Impedance 6 ohm
C – Impedance 8 ohm
RF channel
With the switches 7 and 14 “Channel”, select the RF
channel 1, 2 or 3 that you wish to use. The transmitter
and receiver must be set to the same RF channel.
18
19
15
16
17
7
14
811109
23
91583 GB 20100825.indd 991583 GB 20100825.indd 9 25.08.2010 14:59:48 Uhr25.08.2010 14:59:48 Uhr