Operation Manual

13 • Reflect
Connecting
CAUTION
Risk of injury/damage!
– Lay the cables so that
they do not pose a tripping
hazard.
1. Lay speaker cables from your AV
receiver to each Reflect speaker. If
possible, use high-quality dual core
speaker cables with a diameter of
at least 1 mm
2
to do so.
2. On the back of each speaker there is
a connection terminal with two pole
clamps
(7) . You can connect the
speaker cable directly here or using
pin plugs. Direct connection only is
described here. The terminals are
marked in red (+) and black (-).
(7)
NOTICE
Make sure the polarity is
correct!
– Connect each of the like
coloured terminals with
one another; otherwise the
sound quality will suffer. To
facilitate this, the individual
single wires of the speaker
cables are marked with
different colours or shapes.
3. Split the wire down
by approx. 30 mm
on both ends and
remove approx.
10mm of insulation each.
Twist the single wire so that no
strands are protruding.
4. Turn the connector terminal coun-
terclockwise until loose. Run the
stripped cable end into the now
visible hole. Close the terminal by
turning it counter-clockwise. The
cable has now been clamped in
place.
5. Connect the other end of the
speaker cable to the clamps of
your AV receiver.