Operation Manual

5.5. Setting the channel on the security camera

Remove sealing cap (P) covering the camera’s channel changer.

Set the desired transmission channel (CH1, CH2, CH3 or CH4) by pushing both channel switches

(Q) into the respective position using a pin, as shown in the below illustration.

Then replace sealing cap (P) on channel changer and reconnect the power supply to the mains.

Note:

t 8IFOVTJOHTFWFSBMTFDVSJUZDBNFSBTFOTVSFUIBUFBDIDBNFSBUSBOTNJUTPOBTFQBSBUF

channel. As 4 channels are provided, a maximum of 4 security cameras can be con-

nected. Even if only one camera is used, changing the transmission channel may im-

prove reception.

t Caution! Always disconnect power supply of camera from mains prior to changing

 DIBOOFM

(P)

(Q)

Microphone