User's Manual

10.2.3 Power Supply Direct from Battery
Power can be drawn direct from the battery of the vehicle being inspected
using a specific accessory cable.
If the battery is in the rear of the vehicle, we recommend you
connect the tool directly to the power supply points from the battery
in the area in which you are working.
The display unit can be powered using appropriate cables that can be
attached through the power supply connector.
Proceed as follows:
1.
Connect the battery cable jack to the display unit's power supply connector.
2.
Connect the cable clamps to the battery terminals taking care to respect
the polarity indicated on the cables.
10.2.4 Power Supply Through the Cigar Lighter Socket
Power can also be drawn from the battery of the vehicle being inspected
using a specific cable that can be attached to the display unit through the
power supply connector.
Proceed as follows:
1.
Connect the cigar lighter jack to the display unit power supply connector.
2.
Connect the cigar lighter socket connector to the cigar lighter in the vehicle
being tested.
Whenever the cigar lighter socket is used check that it is always
powered (not only when the key is turned to ON).
37
en