User's Manual
Table Of Contents
- /
- ENGLISH
- NAVIGATOR NANO TECHNICAL MANUAL
- Introduction
- ABOUT THE MANUAL
- 1 LEGEND OF THE SYMBOLS USED
- 2 GLOSSARY
- 3 GENERAL SAFETY REGULATIONS
- 4 NAVIGATOR NANO USER SAFETY
- 5 ENVIRONMENTAL INFORMATION
- 6 OPERATION OF THE TOOL RADIO DEVICES
- 7 NORMATIVE INFORMATION
- 8 INTRODUCTION
- 9 DESCRIPTION
- 10 HOW TO USE THE DEVICE
- 11 MAINTENANCE
- 12 SOLUTIONS TO PROBLEMS
- 13 LEGAL NOTICES
- ENGLISH
10.4.2 Connection via USB
In order to connect via USB use the USB cable provided or,
if necessary, use cables on which "USB HIGH SPEED is
specifically indicated.
This powering mode is recommended during control unit
reprogramming operations.
1.
Device
2.
USB cable
3.
Display unit
Proceed as follows:
1.
Connect the USB mini connector of the USB cable to the device.
2.
Connect the USB connector of the USB cable to the display unit.
3.
Continue with the communication software configuration.
The internal battery of the device will be charged when the
display unit is connected via USB.
For more information regarding the configuration
procedure consult the Software Operating Manual.
43
en