User's Manual

10.8 Self-diagnosis
The data acquired by the tool are displayed on the viewing
unit via the software.
The software provides functions that allow you, for instance,
to do the following:
•
monitor the engineering parameters
•
view and delete the errors detected by the control unit
•
check the various states within the control unit (ex.: engine running/
not running, low beams on/off)
•
view the information related to the control unit
•
test the operation of the devices driven by the control unit
(actuators)
•
carry out permanent adjustments on certain devices
Furthermore, the software provides technical sheets useful in
diagnosis and provides step by step procedures to carry out
particular operations (ex.: resetting warning lights).
All the configuration operations of the tool are performed via
the software.
For more information about the installation of the
software and its use, please refer to the Setup Manual
and the Operation Manual.
49
en