Installation Instructions

10 BLINK CODES
The device uses the flashing of the LEDs to indicate its status.
The status LEDs are: green, red and blue and can flash with different frequencies.
10.1 LED flashes with the Instrument panel On
During normal operating conditions, when the device must connecting to the server to send the
data, the notifications are given through a continuous cycle of 3 flashes.
Each series of flashings is approximately 2 s after the previous one.
The three flashings indicate respectively the status of:
1.
The reception of the position signal from the GPS satellites.
2.
The connection to the GPRS network.
3.
The connection to TEXA Cloud.
The explanation regarding the correct reading of the flashes of the red and green LEDs is below:
Flash Red LED Green LED
1st Invalid GPS position¹. Valid GPS position.
2nd Invalid GPRS connection². Valid GPRS connection.
3rd TEXA Cloud connection not valid. TEXA Cloud connection valid.
¹ INVALID GPS POSITION: This could be due to the vehicle parked
in a closed area or passing through a dead zone where the flow of
the data coming from the satellites is missing or affected by many
interferences (ex.: military areas).
² TEXA CLOUD CONNECTION NOT VALID: This could be due to a
problem with the telephone or Internet service providers caused by
ordinary / extraordinary maintenances on the network, by the weather
conditions or by the passage in an area not covered by the GPRS
signal.
25