Installation Instructions

3.3 Operator Safety
Carefully evaluate the device's installation position.
An improper installation may cause severe damage and injuries.
Safety Measures:
•
Make sure the installation does not compromise the correct functioning of the vehicle's
controls, in particular the brakes and, in general, the safety devices.
The device was manufactured to be electrically safe and
insulated and to work with specific supply voltage levels.
Improper use may expose the operator to the risk of electric
shock, even though of low intensity.
Safety Measures:
•
Wear adequate personal protective equipment during all the operating phases.
•
Do not handle or touch the device or any accessories (e.g. cables) with wet hands.
•
If liquid should penetrate inside the device, immediately disconnect the power supply wiring
and contact technical assistance.
•
Make sure the electric power supply devices (auxiliary batteries) are disconnected and that
they remain so during the entire installation before proceeding with the installation itself.
•
Do not wear metal rings or bracelets when working on batteries.
The device was manufactured to be electrically safe and
mechanically resistant.
However, it is necessary to reduce the risk of damages to the
device that may cause burns.
Safety Measures:
•
Avoid sparks or flames near the installation.
•
Do not use the device if the antenna is damaged.
•
Do not touch the damaged antenna with bare hands.
•
Do not short-circuit the battery terminals.
8