Laptop User Manual

3. Release the Keyboard by pulling the keyboard release tabs forward
(tabs are located underneath the Ctrl and right arrow keys).
4. Disengage the Keyboard using a straight blade screwdriver and gently
lifting up along the front edge of the keyboard.
5. Using the back edge of the keyboard as a hinge, lift the front edge of
the keyboard up and lay it against the display.
6.
Insert the edge of the DIMM Board into the lower connector (refer to
Figure 2-1). Use a rocking motion to fully insert the module. Push
downward on each side of the DIMM module until it snaps in place.
7. Repeat the procedure in Step 6 (upper connector) to install the second
DIMM module.
8. Replace the keyboard assembly and any other components removed in
Step 1.
This completes the expansion memory module installation procedure.
1
Slide Keyboard Release
Tabs toward front of
notebook.
Using a small
flat blade screwdriver,
gently pry keyboard up
along the front edge.
2
Tilt the keyboard back
against the display
Insert the SIMM modules
into the two Main Board
memory connectors
Figure 2-1 Installing Additional Memory
2-2
Installation