CC2650 Packet Error Rate Test Quick Start Guide Version 0.0.2 Updated 17. September 2013 TI Confidential – NDA Restrictions Revised for rev 0.1.
CC2650 Packet Error Rate Test Quick Start Guide Functional Overview This guide describes how to use the Packet Error Rate (PER) test with CC2650. Prerequisites In order to use the PER test, please set up your SmartRF06EB according to the “CC2650 Alpha Release Quick start guide” as the silicon qual package can become damaged if not. Uploading firmware Upload the per_test.hex file to a CC2650 using the SmartRF Flash Programmer. Be sure to do full erase/program/verify of uploaded code.
CC2650 Packet Error Rate Test Quick Start Guide Mode menu In the mode menu, you can select which device is transmitting and which is receiving: BLE Transmitter BLE Receiver After selecting “BLE Receiver”, the device goes directly into receive mode and is ready to receive packets.
CC2650 Packet Error Rate Test Quick Start Guide Current measurement To measure power consumption during test modes, connect a measurement device instead of the jumper ”VDD TO EM” on the SmartRF06EB. This can be e.g. a digital multi meter with the range set to mA or an oscilloscope. To get the lowest possible current consumption, restart the SmartRF06EB after programming the device and remove all the jumpers on the "JTAG Bypass" header (to avoid leakage current to the debugger on the SmartRF06EB).
EVALUATION BOARD/KIT/MODULE (EVM) ADDITIONAL TERMS Texas Instruments (TI) provides the enclosed Evaluation Board/Kit/Module (EVM) under the following conditions: The user assumes all responsibility and liability for proper and safe handling of the goods. Further, the user indemnifies TI from all claims arising from the handling or use of the goods.
FCC Interference Statement for Class B EVM devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
【Important Notice for Users of EVMs for RF Products in Japan】 】 This development kit is NOT certified as Confirming to Technical Regulations of Radio Law of Japan If you use this product in Japan, you are required by Radio Law of Japan to follow the instructions below with respect to this product: 1. 2. 3. Use this product in a shielded room or any other test facility as defined in the notification #173 issued by Ministry of Internal Affairs and Communications on March 28, 2006, based on Sub-section 1.
EVALUATION BOARD/KIT/MODULE (EVM) WARNINGS, RESTRICTIONS AND DISCLAIMERS For Feasibility Evaluation Only, in Laboratory/Development Environments. Unless otherwise indicated, this EVM is not a finished electrical equipment and not intended for consumer use.
