Datasheet

- 11 -

2.5 System / Device Configuration

Prior to capturing data, confirm that the board is in the "ECE (Extended Control Enable)" mode,

The ECE jumper is located in the ADC pin control jumper area as shown in Figure 2. The board

should be sent with this jumper in place. This means that the ADC will be controlled through the

SPI interface and not with jumpers driving the control pins. This allows the user to control the

ADC's behavior through the WaveVision 5 Registers panel.

Figure 5: WaveVision 5 overview of control buttons

Figure 6: WaveVision 5 main window command buttons