Datasheet

ADS1246EVM-PDK Kit Operation

www.ti.com

7.3 Default Jumper Settings and Switch Positions

Figure 3 shows the jumpers found on the EVM and the respective factory default conditions for each.

Figure 3. ADS1246EVM Default Jumper Locations

Table 6 lists the switches found on the EVM and the respective factory default conditions for each.

Table 6. List of Switches

Switch Default Position Switch Description

S1 Left Onboard reference

8 ADS1246EVM-PDK Kit Operation

This section provides information on using the ADS1246EVM-PDK, including setup, program installation,

and program usage.

To prepare to evaluate the ADS1246 with the ADS1246EVM-PDK, complete the following steps:

Step 1. Install the ADCPro software (if not already installed) on a PC.

Step 2. Install the ADS1246EVM-PDK EVM plug-in software.

Step 3. Complete the USB driver installation process.

Step 4. Set up the ADS1246EVM-PDK.

Step 5. Connect the ADS1246EVM-PDK to the computer with a USB cable.

Step 6. Run the ADCPro software.

Each task is described in the subsequent sections of this document.

ADS1146EVM, ADS1246EVM, ADS1146EVM-PDK, ADS1246EVM-PDK SBAU149B–June 2009–Revised May 2011

Submit Documentation Feedback