Datasheet

www.ti.com

Using the ADS1298ECG-FE Software

3.4 ADC Register Tab

The ADC Register tab provides controls to manipulate ADC control registers of the ADS1298. Details of

the control registers are provided in the product datasheet. The ADC Register tab consists of a few

controls and several sub-tabs that further divide the control registers into different functions groups. The

sub-tabs are:

• Channel Registers tab (Section 3.4.2)

• LOFF and RLD tab (Section 3.3)

• GPIO and Other Registers tab (Section 3.4.4)

• Register Map tab (Section 3.4.5)

Figure 8. Channel Registers Tab

3.4.1 Standby and Reset Controls

The Standby control allows the user to place the ADS1298 in standby.

The Reset control allows the user to reset the ADS1298. The Reset Mode determines which mode is

executed when the Reset control is pressed. Device Defaults resets the device to the device defaults;

Programmed Defaults resets the device, then writes the default values for using this software application.

SBAU171C–May 2010–Revised September 2012 ADS1298ECG-FE/ADS1198ECG-FE

Submit Documentation Feedback