User's Manual

BiWaze® Clear System - User Manual Page | 9
3.3.1 Connect Controller Cable
1. Follow the steps in Section 3.1 Connect
the components
2. Insert Aerogen® Solo nebulizer (D) to
the nebulizer port of the Handset (C)
3. Connect the flat end of the Aerogen®
Solo Controller Cable into the
Aerogen® Solo (D) nebulizer
4. Connect the round end of the
Aerogen® Solo Controller Cable to
the Aerogen® Solo port located on the
side panel of the control unit
Note: For optimum use of the Aerogen®
Solo, ensure it is correctly orientated on
the handset as shown below
3.3.2 Adding Medication to Aerogen® Solo
• WARNING - To avoid damage to the Aerogen® Solo, do not use a syringe with a needle.
• WARNING - During use observe for correct functioning of the nebulizer.
• WARNING - The maximum capacity of the nebulizer is 6 ml.
To avoid damage to the Aerogen® Solo Nebulizer:
• Do not apply undue pressure to the domed aperture plate in the center of the nebulizer.
• Do not push out the Aerogen® Solo Vibronic® aerosol generator.
• Do not attempt to clean the nebulizer.