Datasheet

5 Bill of Materials
6 References
www.ti.com Bill of Materials
Table 4 lists the materials required for the bq24083EVM.
Table 4. bq24083EVM BOM
COUNT REF DES VALUE DESCRIPTION SIZE PART NUMBER MFR
2 C1, C2 1 µ F Capacitor, Ceramic, 16V, X5R, 10% 0805 Std Std
LTST-
1 D1 Diode, LED, Red, 2.1-V, 20-mA, 20-mcd 0603 LTST-C190CKT Lite On
C190CKT
LTST-
2 D2, D3 Diode, LED, Green, 2.1-V, 20-mA, 6-mcd 0603 LTST-C190CKT Lite On
C190CKT
2 J1, J2** ED555/2DS Terminal Block, 2-pin, 6-A, 3,5 mm 0.27 x 0.25 INCH ED555/2DS OST
5 JMP1–JMP5 PTC36SAAN Header, 2-pin, 100-mil spacing, (36-pin strip) 0.100 x 2 PTC36SAAN Sullins
3 R1, R2, R6 1.5 k Resistor, Chip, 1/16-W, 1% 0603 Std Std
1 R3 1.13 k Resistor, Chip, 1/16-W, 1% 0603 Std Std
3 R4, R7, R8 20 k Resistor, Chip, 1/16-W, 1% 0603 Std Std
1 U1 bq24083DRC IC, Stand-alone linear charger DRC10 bq24083DRC TI
1 — PCB, 2 In x 1 In x 0.31 In HPA344 Any
5 Shunt, 100-mil, black 0.1 929950-00 3M
Shunt
(5) (6)
Notes: 1. Shunts are placed on pins 1 and 2 for jumpers JMP1, JMP2, and JMP3.
2. For JMP4 and JMP5 place shunt on just one pin (do no short pins 1 and 2 with shunt)
bq24083, 1-A Single-Chip, Li-Ion and Li-Pol Charger IC data sheet (SLUS848) .
SLUU315 – June 2008 bq24083 1-A, Single-Cell Li-Ion and Li-Polymer Charge Management IC EVM 7
Submit Documentation Feedback