Datasheet

ApplyInput
Power
SetInputCurrentLimitto 100 mA
andStartCharge
PerformISET & OUT shorttests
RememberISET2 State
Setchargecurrent
basedonISET2 truth
table.
Returnto
Charge
Ispowergood?
V
BAT
+V
DT
< V
IN
< V
OVP
& V
UVLO
< V
IN
No
Yes
Ischipenabled?
V
TS
> V
EN
No
Yes
TurnonPGFET
PGpinLOW
bq24090, bq24091
bq24092, bq24093
bq24095
SLUS968E –JANUARY 2010–REVISED SEPTEMBER 2013 www.ti.com
Figure 20. bq2409x Power-Up Flow Diagram
Overvoltage-Protection (OVP) – Continuously Monitored
If the input source applies an overvoltage, the pass FET, if previously on, turns off after a deglitch, t
BLK(OVP)
. The
timer ends and the CHG and PG pin goes to a high impedance state. Once the overvoltage returns to a normal
voltage, the PG pin goes low, timer continues, charge continues and the CHG pin goes low after a 25ms
deglitch. PG pin is optional on some packages
16 Submit Documentation Feedback Copyright © 2010–2013, Texas Instruments Incorporated
Product Folder Links: bq24090 bq24091 bq24092 bq24093 bq24095