Datasheet

www.ti.com

Bill of Materials, Board Layout, and Schematic

Table 4. Bill of Materials (continued)

Count

-001 -002 RefDes Value Description Size Part Number MFR

1 1 R26 10k Resistor, Chip, 1/16W, 5% 0603 STD STD

1 1 R27 4.99k Resistor, Chip, 1/16W, 1% 0603 STD STD

2 2 R28, R31 100k Resistor, Chip, 1/16W, 1% 0603 STD STD

1 1 R30 100k Resistor, Chip, 1/16W, 1% 0603 STD STD

1 1 R18 57.6k Resistor, Chip, 1/16W, 1% 0603 STD STD

1 1 R32 13.7k Resistor, Chip, 1/16W, 1% 0603 STD STD

0 0 TP1, TP3–TP6 TP-SMALL Test Point, 0.020 Hole 0.100 x 0.100 N/A N/A

inch

1 1 TP2 131-5031-00 Adaptor, 3.5-mm probe clip 0.200 inch 131-4244-00 or Tektronix

131-5031-00

13 13 TP7 - TP19 5002 Test Point, White, Thru Hole Color Keyed 0.100 x 0.100 5002 Keystone

inch

1 1 TP20 5001 Test Point, Black, Thru Hole Color Keyed 0.100 x 0.100 5001 Keystone

inch

1 1 U1 BQ24133RHL IC, Power Path Selector Stand-alone VQFN BQ24133RHL TI

Charger

1 1 — PCB, 2.65 In x 3.00 In x 0.062 In HPA715 Any

4 4 Bumper foot (install after final wash) 0.440 x 0.2 SJ-5303 3M

4 4 Shunt, 100-mil, Black 0.100 929950-00 3M

1 1 — Label (See Note 5) 1.25 x 0.25 inch THT-13-457-10 Brady

Notes 1. These assemblies are ESD sensitive, ESD precautions shall be observed.

2. These assemblies must be clean and free from flux and all contaminants.

Use of no clean flux is not acceptable.

3. These assemblies must comply with workmanship standards IPC-A-610 Class 2.

4. Ref designators marked with an asterisk ('**') cannot be substituted.

All other components can be substituted with equivalent MFG's components.

5. Install label after final wash. Text shall be 8 pt font. Text shall be per Table 1.

Table 1

Assembly Number Text

HPA715-001 BQ24133EVM-715-5V

HPA715-002 BQ24133EVM-715-15V

SLUU476–December 2010 bq24133EVM Stand-Alone Synchronous, Switch-Mode, Battery-Charge

Controller With Integrated N-MOSFETs and Power Path Selector

Submit Documentation Feedback