Appliance Trim Kit User Manual

swru266
6/25
4 Getting Started
4.1 Development Kit Content
The development kit includes the following main components:
RF remote control
A complet
e cost optimized RF4CE remote
control reference design with integrated PCB
antenna. The remote control can be
programmed using the debug interface.
Target Module
Interface board for connecting I/O signals to
typical remote applications. The following
interfaces are accessible:
- UART over USB virtual serial port
- UART, CMOS signal level
- SPI
- I
2
C
- IR receiver/transmitter
CC2533EM
This is the CC2533 Evaluation Module (EM)
with the RF IC reference design. Use the EM
as reference design for antenna and RF
lay
out. To be plugged into the Receiver
module. The CC2533EM module includes
both a no-
cost PCB antenna and an SMA
connector with external antenna. The
antenna can be selected with a 0-
ohm
resistor.
The PCB antenna is used by
default.
CC Debugger
USB Debug
Interface for programming and
debugging applications running on the
remote control and target board.
For programming the CC Debugger is used
with the SmartRF flash programmer SW
For In-
Circuit Emulator the CC Debugger is
used with the IAR embedded workbench