AMPAK Technology Inc. Advanced Module Packaging Solution 正基科技股份有限公司 CC2564MODNEM User manual Revision History Date 2013/12/24 AMPAK Technology Inc. i Doc. NO: Revision Content Initial released www.ampak.com.tw Revised By Version Rue 1.
Contents 1. CC2564MODN evaluation module introduction ....................................................... 1 2. PIN Description/ Operating Ratings/ Operating temperature ................................. 3 3. Federal Communication Commission Interference Statement ................................ 6 4. Industry Canada statement ......................................................................................... 7 AMPAK Technology Inc. Doc. NO: www.ampak.com.
1. CC2564MODN evaluation module introduction CC2564MODN evaluation module (EM) likes as figure1. That is designed for Bluetooth 2.1+EDR application. The bottom views like as figure2. It is also designed for TI’s MSP430 experimenter board. It is subject to provide a convenient environment for customer’s verification on Bluetooth function. There are controller pins on evaluation board which describes as below. Figure1. Top view of CC2564MODNEM AMPAK Technology Inc. Doc. NO: www.ampak.com.
Figure2. Bottom view of CC2564MODNEM Interface highlights: 1. U5: CC2564MODN SIP module. 2. P3: U.FL connector let RF signal in/out path, which R30 need tie on 0ohm. 3. J4: VBAT_MCU: 3V3 for main system power path form RF2. 4. J3: VBAT_EDGE: 3V3 for main system power path form P2 5. J2&R10: VBAT_CC: 3V3 for CC2564MODN main power 6. J1&R7: VDO_1V8: V8 for system IO level path 7. RF1&RF2&P2: For TI’s experimenter board IO used. AMPAK Technology Inc. Doc. NO: www.ampak.com.
2. PIN Description/ Operating Ratings/ Operating temperature 2.1 PIN Description Def. Dir. Connector No. Pin Name RF1 1,19 GND 3 HCI_CTS_3V3 I HCI UART clear-to-send 5 SLOW_CLK_3V3 I 32.768-KHz clock in 7 HCI_RX_3V3 I HCI UART data receive 9 HCI_TX_3V3 O HCI UART data transmit others Not connected 2 GND 7,9 +3V3 I Connect to +3.
Connector No. Pin Name Def. Dir. Description of Options (Common) P2 1 SLOW_CLK_EDGE I 32.768-KHz clock in 8 1V8_IN I Connect to +1.
2.2 Operating Ratings Test conditions: At room temperature 25°C Description Input supply Voltage Min. Typ. Max. Unit 2.2 3.3 4.85.5 V 2.3 Operating temperature Operating temperature AMPAK Technology Inc. Doc. NO: -40°C to 85°C www.ampak.com.
3. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
4. Industry Canada statement This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
