User's Guide
Table Of Contents
- CC3235MODSF SimpleLink™ Wi-Fi® and IoT Solution With MCU LaunchPad™ Hardware
- Table of Contents
- 1 Introduction
- 2 Hardware
- 2.1 Block Diagram
- 2.2 Hardware Features
- 2.2.1 Key Benefits
- 2.2.2 XDS110-Based Onboard Debug Probe
- 2.2.3 Debug Probe Connection: Isolation Jumper Block
- 2.2.4 Application (or "Backchannel") UART
- 2.2.5 JTAG Headers
- 2.2.6 Using the XDS110 Debug Probe with a Different Target
- 2.2.7 Power Connections
- 2.2.8 Reset Pullup Jumper
- 2.2.9 Clocking
- 2.2.10 I2C Connection
- 2.2.11 Sense on Power (SOP)
- 2.2.12 Push-Buttons and LED Indicators
- 2.3 Electrical Characteristics
- 2.4 Antenna Characteristics
- 2.5 BoosterPack™ Header Pin Assignment
- 3 Layout Guidelines
- 4 Operational Setup and Testing
- 5 Development Environment Requirements
- 6 Additional Resources
- 7 Assembly Drawing and Schematics
- Revision History
- Important Notice
TI Confidential – NDA Restrictions
CC3235MODSF12MOBR
Acc
BMA280
Temperature
Sensor
TMP116
Two 20-pin LaunchPad headers
(compatible with TI MCU standard)
INT (GPIO13)
I
2
C
FTDI
FT2232D
and
SWD Circuit
USB
Connector
LDO
3.3 V
VCC
Two AA
Battery
Connectors
Reverse
Protection
Push buttons
GPIO13, GPIO22
RGB LED
GPIO9, GPIO10, GPIO11
JTAG and SWD
UART (Flashing)
Hardware
www.ti.com
12
SWRU548A–February 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
CC3235MODSF LaunchPad™ Development Kit (LAUNCHCC3235MOD)
Figure 4 shows a functional block diagram of the LAUNCHCC3235MOD SimpleLink LaunchPad.
Figure 4. LAUNCHCC3235MOD Functional Block Diagram