User's Manual

eZ430-Chronos Quick Start

1. Run Chronos-setup.exe to install

the software and drivers.

2. Insert the RF Access Point

into an available USB port.

3. Open the eZ430-Chronos Control application to

conﬁgure the watch. You will be able to sync the

time with your PC, control PowerPoint slides

wirelessly, plot your acceleration data and more

4. In order to reprogram the Chronos watch,

you will need to disassemble the watch

and connect to the included

eZ430 emulator.

Congratulations on receiving your eZ430-Chronos, the world’s ﬁrst wearable wireless development tool.

Complete the following steps to get your watch up and running.

Find all of the software and documentation online at www.ti.com/chronoswiki. Refer to the eZ430-Chronos

User Guide for detailed installation instructions, schematics and troubleshooting.

For the latest updates check www.ti.com/ez430

PAGE 1
eZ430-Chronos Quick Start Congratulations on receiving your eZ430-Chronos, the world’s first wearable wireless development tool. Complete the following steps to get your watch up and running. 1. Run Chronos-setup.exe to install 2. Insert the RF Access Point the software and drivers. into an available USB port. 3. Open the eZ430-Chronos Control application to configure the watch.
PAGE 2
eZ430-Chronos Quick Start The eZ430-Chronos has to be disassembled and removed from the enclosure to reprogram with custom applications. You can use the included screwdriver to remove the module. Disassembly Reassembly 1. Remove metal back using included screwdriver. 2. Carefully remove the watch module. 1. Gently insert the watch module. 2. Ensure that metal strips on watch module 3. Remove the battery. 4. Connect to eZ430 emulator. slide over buttons. 3. Replace the back with screws.