User's Manual

Operations Manual

Sontheim_Telemetry_Verona_Gen 4_operations manual.docx Version of the Document: 2.1

6. Preliminary Note

This document applies to devices of the type COMhawk xt - Verona Gen 4. This document is

intended for specialists. These specialists are people who are qualified by their appropriate

training and their experience to see risks and to avoid possible hazards that may be caused

during operation or maintenance of the device. The document contains information about the

correct handling of the device.

Read this document before use to familiarize yourself with operating conditions, installation and

operation. Keep this document during the entire duration of use of the device.

6.1. Symbols used

Instructions

Reaction, result

[…] Designation of pushbuttons, buttons or indications

Cross-reference

Important note

Non-compliance can result in malfunction or interference

Information

Supplementary note

7. Safety instructions

7.1. General

These instructions contain texts and figures concerning the correct handling of the device and

must be read before installation or use. Observe the operating instructions. Non-observance of

the instructions, operation which is not in accordance with use as prescribed below, wrong

installation or incorrect handling can seriously affect the safety of operators and machinery.

7.2. Target Group

These instructions are intended for authorized persons according to the EMC and low-voltage

directives. The device must only be installed, connected and put into operation by a qualified

person.

7.3. Electrical Connection

The connections may only be supplied with the signals indicated in the technical data and/or on

the device label.

7.4. Tampering with the Device

In case of malfunctions or uncertainties please contact the manufacturer. Tampering with the

device can seriously affect the safety of operators and machinery. It is not permitted and leads

to the exclusion of any liability and warranty claims.