User manual

4.1. Toolbar

The list of available COM ports will automatically be updated when the eZ430-RF2480

dongle is connected or disconnected. It is also possible to force refresh of the list by

clicking on the green “refresh” button

If the applicable COM port can be found when “refresh” has been clicked, the application

will automatically try to capture data from the COM port. If communication is successfully

established, the “capture” button

will be disabled and both the “Pause capture” button

and the “Stop capture” button will be enabled. If more than one device with the

applicable COM port is connected to the PC, it could be that wrong COM port gets

selected. In this case the first port in the list will be selected. If this was not the intended

device to connect to, the appropriate COM port must be selected manually.

Using the “Stop capture” button will cause the nodes on display to be removed from the

screen once the “Start capture” button is clicked. This differs from the “Pause capture”

button which will maintain the nodes on the screen when the “Start capture” button is

clicked.

The user manual is a pdf file that can be opened by clicking on the “help” button