Operation Manual

www.ti.com

eZ430-RF Debug Interface

9. Verify correct properties of the port settings (see Figure B-8).

Figure B-8. CC1111 Port Settings

B.2 eZ430-RF Debug Interface

1. Install an IDE of your choice (see Section 3.6), it contains the drivers for the debug interfaces

2. Connect the eZ430-RF USB Debug Interface to an USB port of the PC

3. Windows should now recognize the new hardware as an "MSP430 XXX x.xx.xx" (see Figure B-9). The

device name may be different from the one shown here.

Figure B-9. eZ430-RF Windows Driver Installation

4. The drivers are installed automatically without any user interaction.

5. The USB debug interface is installed and ready to use. The Windows Device Manager lists a new

entries for a Human Interface Device and the MSP430 Application UART (COMx) (see Figure B-10).

111

SLAU292D–November 2009–Revised March 2011 Detailed Hardware Driver Installation Guide

Submit Documentation Feedback