Operation Manual

www.ti.com

eZ430-Chronos Sports Watch Software

3.2.2.5 PowerPoint Mode - RF

This mode requires the eZ430-Chronos Control Center PC software.

Press "#" until "PPt" is shown (see Figure 3-1). This mode allows control of a PowerPoint presentation by

translating button pushes on the watch into keystrokes of the PC keyboard. No acceleration or other data

is transmitted. The default settings are:

• "#" - Go to presentation mode (F5)

• "*" - Previous slide (Left)

• "UP" - Next slide (Right)

The Control Center allows user defined key settings (including combinations) - see Section 3.3.2.

Secondary function: Start/stop transmission of button pushes. Pushing "DOWN" starts/stops the pairing

process or stops the transmission (the access point on the PC must be started from the eZ430-Chronos

Control Center (see Section 3.3.1). The RF icon on the LCD flashes when the radio is active; if pairing

fails, the icon disappears. The top LCD line shows the time during the pairing until the data transmission is

disabled.

Set function: None

3.2.2.6 Sync Mode - RF

This mode requires the eZ430-Chronos Control Center PC software.

Press "#" until "SYnC" is shown (see Figure 3-1). This mode allows doing a variety of watch settings

conveniently from the eZ430-Chronos Control Center PC software over the air (see Section 3.3.3).

• Time settings

• Date settings

• Altitude calibration

• Temperature calibration

Secondary function: Start/stop link for Sync Mode. Pushing "DOWN" starts/stops the pairing process or

stop the link (the access point on the PC must be started first from the eZ430-Chronos Control Center

(see Section 3.3.3). The RF icon on the LCD flashes when the radio is active. If the pairing fails, it

disappears. After a successfully received message, the LCD shows "DONE". The top LCD line is off

during the pairing and until the Sync Mode is disabled.

Set function: None

SLAU292D–November 2009–Revised March 2011 eZ430-Chronos Software

Submit Documentation Feedback