User manual

5 Supported Devices
TX
RX
3.6 V
TEST/SBWTCK
RST/SBWTDIO
GND
Supports eZ430-F2013
and T2012 target boards
6 MSP430 Application UART
Supported Devices www.ti.com
The eZ430-RF USB debugging interface may be used as a standard Flash Emulation Tool through its
Spy-Bi-Wire interface. The eZ430-RF USB debugging interface supports the following MSP430 families:
• MSP430F20xx
• MSP430F22xx
The connector on the USB debugging interface is backward compatible with the eZ430-F2013 and T2012
target boards.
Figure 4. eZ430-RF2500 USB Debugging Interface 6-Pin Male Header
The eZ430-RF USB debugging interface features a back channel MSP430 Application UART that may be
used independently of a debug session. This allows the user to transfer serial data to a terminal window at
a fixed rate of 9600 bps with no flow control. See Figure 5 for typical settings.
Figure 5. 9600 bps With No Flow Control
Check the Device Manager for COM port assignment of the MSP430 Application UART. For more details,
see Section 14 .
eZ430-RF2500 Development Tool10 SLAU227E – September 2007 – Revised April 2009
Submit Documentation Feedback