Datasheet

LM2595

SNVS122B –MAY 1999–REVISED APRIL 2013

www.ti.com

In many cases the preferred mode of operation is the continuous mode. It offers greater output power, lower

peak switch, inductor and diode currents, and can have lower output ripple voltage. But it does require larger

inductor values to keep the inductor current flowing continuously, especially at low output load currents and/or

high input voltages.

To simplify the inductor selection process, an inductor selection guide (nomograph) was designed (see Figure 22

through Figure 25). This guide assumes that the regulator is operating in the continuous mode, and selects an

inductor that will allow a peak-to-peak inductor ripple current to be a certain percentage of the maximum design

load current. This peak-to-peak inductor ripple current percentage is not fixed, but is allowed to change as

different design load currents are selected. (See Figure 29.)

Figure 29. (ΔI

IND

) Peak-to-Peak

Inductor Ripple Current (as a Percentage

of the Load Current) vs Load Current

By allowing the percentage of inductor ripple current to increase for low load currents, the inductor value and size

can be kept relatively low.

When operating in the continuous mode, the inductor current waveform ranges from a triangular to a sawtooth

type of waveform (depending on the input voltage), with the average value of this current waveform equal to the

DC output load current.

Inductors are available in different styles such as pot core, toroid, E-core, bobbin core, etc., as well as different

core materials, such as ferrites and powdered iron. The least expensive, the bobbin, rod or stick core, consists of

wire wound on a ferrite bobbin. This type of construction makes for an inexpensive inductor, but since the

magnetic flux is not completely contained within the core, it generates more Electro-Magnetic Interference (EMl).

This magnetic flux can induce voltages into nearby printed circuit traces, thus causing problems with both the

switching regulator operation and nearby sensitive circuitry, and can give incorrect scope readings because of

induced voltages in the scope probe. Also see section on OPEN CORE INDUCTORS.

When multiple switching regulators are located on the same PC board, open core magnetics can cause

interference between two or more of the regulator circuits, especially at high currents. A toroid or E-core inductor

(closed magnetic structure) should be used in these situations.

The inductors listed in the selection chart include ferrite E-core construction for Schott, ferrite bobbin core for

Renco and Coilcraft, and powdered iron toroid for Pulse Engineering.

Exceeding an inductor's maximum current rating may cause the inductor to overheat because of the copper wire

losses, or the core may saturate. If the inductor begins to saturate, the inductance decreases rapidly and the

inductor begins to look mainly resistive (the DC resistance of the winding). This can cause the switch current to

rise very rapidly and force the switch into a cycle-by-cycle current limit, thus reducing the DC output load current.

This can also result in overheating of the inductor and/or the LM2595. Different inductor types have different

saturation characteristics, and this should be kept in mind when selecting an inductor.

The inductor manufacturer's data sheets include current and energy limits to avoid inductor saturation.

Product Folder Links: LM2595