Datasheet

Note: This register can only be accessed from privileged mode.

The STRELOAD register specifies the start value to load into the SysTick Current Value

(STCURRENT) register when the counter reaches 0. The start value can be between 0x1 and

0x00FF.FFFF. A start value of 0 is possible but has no effect because the SysTick interrupt and the

COUNT bit are activated when counting from 1 to 0.

SysTick can be configured as a multi-shot timer, repeated over and over, firing every N+1 clock

pulses, where N is any value from 1 to 0x00FF.FFFF. For example, if a tick interrupt is required

every 100 clock pulses, 99 must be written into the RELOAD field.

SysTick Reload Value Register (STRELOAD)

Base 0xE000.E000

Offset 0x014

Type R/W, reset 0x0000.0000

16171819202122232425262728293031

RELOADreserved

R/WR/WR/WR/WR/WR/WR/WR/WROROROROROROROROType

0000000000000000Reset

0123456789101112131415

RELOAD

R/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WType

0000000000000000Reset

DescriptionResetTypeNameBit/Field

Software should not rely on the value of a reserved bit. To provide

compatibility with future products, the value of a reserved bit should be

preserved across a read-modify-write operation.

0x00ROreserved31:24

Reload Value

Value to load into the SysTick Current Value (STCURRENT) register

when the counter reaches 0.

0x00.0000R/WRELOAD23:0

111June 18, 2012

Texas Instruments-Production Data

Stellaris

LM3S8962 Microcontroller

NRND: Not recommended for new designs.