Datasheet

0x408

Note: Offset is relative to System Control base address of 0x400FE000.

This register stores the execute-only protection bits for each 2-KB flash block (FMPREn stores the

execute-only bits). This register is loaded during the power-on reset sequence. The factory settings

for the FMPREn and FMPPEn registers are a value of 1 for all implemented banks. This achieves

a policy of open access and programmability. The register bits may be changed by writing the

specific register bit. However, this register is R/W0; the user can only change the protection bit from

a 1 to a 0 (and may NOT change a 0 to a 1). The changes are not permanent until the register is

committed (saved), at which point the bit change is permanent. If a bit is changed from a 1 to a 0

and not committed, it may be restored by executing a power-on reset sequence. For additional

information, see the "Flash Memory Protection" section.

Flash Memory Protection Program Enable 2 (FMPPE2)

Base 0x400F.E000

Offset 0x408

Type R/W, reset 0xFFFF.FFFF

16171819202122232425262728293031

PROG_ENABLE

R/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WType

1111111111111111Reset

0123456789101112131415

PROG_ENABLE

R/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WR/WType

1111111111111111Reset

DescriptionResetTypeNameBit/Field

Flash Programming Enable

Configures 2-KB flash blocks to be execute only. The policies may be

combined as shown in the table “Flash Protection Policy Combinations”.

DescriptionValue

Enables 256 KB of flash.0xFFFFFFFF

0xFFFFFFFFR/WPROG_ENABLE31:0

287June 18, 2012

Texas Instruments-Production Data

Stellaris

LM3S8962 Microcontroller

NRND: Not recommended for new designs.