Datasheet

DescriptionResetTypeNameBit/Field
Receive Error Interrupt
When set, this bit indicates that a receive error has been detected by
the Ethernet Controller.
0RCRXER_INT6
Page Receive Interrupt
When set, this bit indicates that a new page has been received from the
link partner during auto-negotiation.
0RCPRX_INT5
Parallel Detection Fault Interrupt
When set, this bit indicates that a parallel detection fault has been
detected by the Ethernet Controller during the auto-negotiation process.
0RCPDF_INT4
LP Acknowledge Interrupt
When set, this bit indicates that an FLP burst has been received with
the ACK bit set in the MR5 register during auto-negotiation.
0RCLPACK_INT3
Link Status Change Interrupt
When set, this bit indicates that the link status has changed from OK to
FAIL.
0RCLSCHG_INT2
Remote Fault Interrupt
When set, this bit indicates that a remote fault condition has been
signaled by the link partner.
0RCRFAULT_INT1
Auto-Negotiation Complete Interrupt
When set, this bit indicates that the auto-negotiation sequence has
completed successfully.
0RCANEGCOMP_INT0
June 18, 2012642
Texas Instruments-Production Data
Ethernet Controller
NRND: Not recommended for new designs.