Datasheet

- T

)

P =

LM5113

SNVS725F –JUNE 2011–REVISED APRIL 2013

www.ti.com

The Load of High-Side Driver is a GaN FET

with Total Gate Charge of 10nC

Figure 20. Reverse Recovery Power Loss of

Bootstrap Diode V

=50V

The sum of the driver loss and the bootstrap diode loss is the total power loss of the IC. For a given ambient

temperature, the maximum allowable power loss of the IC can be defined as

(5)

Layout Considerations

Small gate capacitance and miller capacitance enable enhancement mode GaN FETs to operate with fast

switching speed. The induced high dv/dt and di/dt, coupled with a low gate threshold voltage and limited

headroom of enhancement mode GaN FETs gate voltage, make the circuit layout crucial to the optimum

performance. Following are some hints.

1. The first priority in designing the layout of the driver is to confine the high peak currents that charge and

discharge the GaN FETs gate into a minimal physical area. This will decrease the loop inductance and

minimize noise issues on the gate terminal of the GaN FETs. The GaN FETs should be placed close to the

driver.

2. The second high current path includes the bootstrap capacitor, the local ground referenced VDD bypass

capacitor and low-side GaN FET. The bootstrap capacitor is recharged on a cycle-by-cycle basis through the

bootstrap diode from the ground referenced VDD capacitor. The recharging occurs in a short time interval

and involves high peak current. Minimizing this loop length and area on the circuit board is important to

ensure reliable operation.

3. The parasitic inductance in series with the source of the high-side FET and the low-side FET can impose

excessive negative voltage transients on the driver. It is recommended to connect HS pin and VSS pin to the

respective source of the high-side and low-side transistors with a short and low-inductance path.

4. The parasitic source inductance, along with the gate capacitor and the driver pull-down path, can form a LCR

resonant tank, resulting in gate voltage oscillations. An optional resistor or ferrite bead can be used to damp

the ringing.

5. Low ESR/ESL capacitors must be connected close to the IC, between VDD and VSS pins and between the

HB and HS pins to support the high peak current being drawn from VDD during turn-on of the FETs. It is

most desirable to place the VDD decoupling capacitor and the HB to HS bootstrap capacitor on the same

side of the PC board as the driver. The inductance of vias can impose excessive ringing on the IC pins.

6. To prevent excessive ringing on the input power bus, good decoupling practices are required by placing low

ESR ceramic capacitors adjacent to the GaN FETs.

The following figures show recommended layout patterns for WSON-10 package and DSBGA package

respectively. Two cases are considered: (1) Without any gate resistors; (2) With an optional turn-on gate resistor.

It should be noted that 0402 DSBGA package is assumed for the passive components in the drawings. For

information on DSBGA package assembly, refer to Application Note AN-1112 SNVA009.

Product Folder Links: LM5113