Datasheet

MSP430G2x53
MSP430G2x13
www.ti.com SLAS735J –APRIL 2011–REVISED MAY 2013
MIXED SIGNAL MICROCONTROLLER
1
FEATURES
• Low Supply-Voltage Range: 1.8 V to 3.6 V • Universal Serial Communication Interface
(USCI)
• Ultra-Low Power Consumption
– Enhanced UART Supporting Auto Baudrate
– Active Mode: 230 µA at 1 MHz, 2.2 V
Detection (LIN)
– Standby Mode: 0.5 µA
– IrDA Encoder and Decoder
– Off Mode (RAM Retention): 0.1 µA
– Synchronous SPI
• Five Power-Saving Modes
– I
2
C™
• Ultra-Fast Wake-Up From Standby Mode in
• On-Chip Comparator for Analog Signal
Less Than 1 µs
Compare Function or Slope Analog-to-Digital
• 16-Bit RISC Architecture, 62.5-ns Instruction
(A/D) Conversion
Cycle Time
• 10-Bit 200-ksps Analog-to-Digital (A/D)
• Basic Clock Module Configurations
Converter With Internal Reference, Sample-
– Internal Frequencies up to 16 MHz With
and-Hold, and Autoscan (See Table 1)
Four Calibrated Frequency
• Brownout Detector
– Internal Very-Low-Power Low-Frequency
• Serial Onboard Programming,
(LF) Oscillator
No External Programming Voltage Needed,
– 32-kHz Crystal
Programmable Code Protection by Security
– External Digital Clock Source
Fuse
• Two 16-Bit Timer_A With Three
• On-Chip Emulation Logic With Spy-Bi-Wire
Capture/Compare Registers
Interface
• Up to 24 Capacitive-Touch Enabled I/O Pins
• Family Members are Summarized in Table 1
• Package Options
– TSSOP: 20 Pin, 28 Pin
– PDIP: 20 Pin
– QFN: 32 Pin
• For Complete Module Descriptions, See the
MSP430x2xx Family User’s Guide (SLAU144)
DESCRIPTION
The Texas Instruments MSP430 family of ultra-low-power microcontrollers consists of several devices featuring
different sets of peripherals targeted for various applications. The architecture, combined with five low-power
modes, is optimized to achieve extended battery life in portable measurement applications. The device features a
powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency.
The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less than 1 µs.
The MSP430G2x13 and MSP430G2x53 series are ultra-low-power mixed signal microcontrollers with built-in 16-
bit timers, up to 24 I/O capacitive-touch enabled pins, a versatile analog comparator, and built-in communication
capability using the universal serial communication interface. In addition the MSP430G2x53 family members
have a 10-bit analog-to-digital (A/D) converter. For configuration details see Table 1.
Typical applications include low-cost sensor systems that capture analog signals, convert them to digital values,
and then process the data for display or for transmission to a host system.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Copyright © 2011–2013, Texas Instruments Incorporated
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.