User manual

16
13. Use a ball point pen to press the reset button on the back of the hub.
Hold the button in until the LEDs are solid amber, then release the
button. This resets the hub to its factory default settings. Repeat for
each hub in the classroom.
A serial number is printed on the back of each network hub. The last
five digits of the serial number of each hub are displayed on the
screen as the access point recognizes and associates with each hub.
14. Compare the number of hubs that are found with the total number
of hubs in your classroom. (For example, you know you have 10 hubs
in your classroom, but only 8 were found.)
15. If some of the hubs were not found, match the serial numbers on the
screen with the hubs in the classroom to identify which hubs were
found. Use a sticker or some other method to mark the hubs that
were found, and then press the reset button again on the hubs that
were not found.
16. When all the hubs have been found (total number of hubs matches
what you have in your classroom), click
OK.
Reset button
Network hub, bottom view