User manual

29
Messages
Problem or
message
Possible solutions
Device not
found
• Make sure the data cable from the calculator
is properly connected to the network
connector.
• Ensure that the access point is connected and
its power adapter is plugged in.
Problem or
message
Possible causes or solutions
Device is
incorrectly
configured
An access point
was located, but
one or more
configuration
parameters are
set incorrectly.
Troubleshoot the Access Point procedure to
reconfigure this device. (See “Setting up your
TI-Navigator™ network the first time” on
page 11.)
Device did not
respond, or
Device not
found
No access point
was located by
the system. The
hubs cannot be
configured until
this is corrected.
• The access point has not yet been added to
the system.
• The access point is turned on but still
initializing.
• Run Network Manager and click on
Check
Access Point
.
Cannot add the
access point to
the network
• The access point is not in a receptive state. If
its configuration has been corrupted, reset
the access point to the original settings. You
will need to reconfigure the access point and
add all the hubs to the network again.