Datasheet

www.ti.com
ABSOLUTE MAXIMUM RATINGS
RECOMMENDED OPERATING CONDITIONS
DC ELECTRICAL CHARACTERISTICS
ONET1191P
SLLS754 – SEPTEMBER 2006
over operating free-air temperature range (unless otherwise noted)
(1)
VALUE UNIT
V
CC
Supply voltage
(2)
–0.3 to 4 V
V
DIN+
, V
DIN–
Voltage at DIN+, DIN–
(2)
0.5 to 4 V
V
LOS
, V
COC+
, V
COC–
, V
TH
, V
DOUT+
, Voltage at LOS, COC+, COC–, TH, DOUT+, DOUT–
(2)
–0.3 to 4 V
V
DOUT–
V
DIN,DIFF
Differential voltage between DIN+ and DIN– ± 1.25 V
I
LOS
Current into LOS 1 mA
I
DIN+
, I
DIN–
, I
DOUT+
, I
DOUT–
Continuous current at inputs and outputs 20 mA
ESD ESD rating at all pins 1.5 kV (HBM)
T
J,max
Maximum junction temperature 125 ° C
T
STG
Storage temperature range –65 to 85 ° C
T
A
Characterized free-air operating temperature range –40 to 85 ° C
T
LEAD
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 260 ° C
(1) Stresses beyond those listed under absolute maximum ratings may cause permanent damage to the device. These are stress ratings
only, and functional operation of the device at these or any other conditions beyond those indicated under recommended operating
conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
(2) All voltage values are with respect to network ground terminal.
MIN TYP MAX UNIT
V
CC
Supply voltage 2.9 3.3 3.6 V
T
A
Operating free-air temperature –40 85 ° C
Disable input high voltage 2 V
Disable input low voltage 0.25 V
Optimum LOS threshold resistor 32 62 k Ω
R
VAR
range 0 open k Ω
over recommended operating conditions, outputs connected to a 50- Ω load, R
VAR
= open (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
V
CC
Supply voltage 2.9 3.3 3.6 V
I
VCC
Supply current DISABLE = LOW 33 49 mA
R
IN
Data input resistance Single-ended to COC pins 50 Ω
R
OUT
Data output resistance Single-ended, referenced to V
CC
50 Ω
Voltage at TH pin 1.25 V
LOS HIGH voltage 10-k Ω pullup to V
CC
, I
SOURCE
= 50 µ A 2.4
LOS LOW voltage 10-k Ω pullup to V
CC
, I
SINK
= 200 µ A 0.5 V
4
Submit Documentation Feedback