Calculator User Manual

Chapter 16: Programming 433
Note: To move the cursor to the beginning of a command line, press y|; to move to
the end, press y~. To scroll the cursor down seven command lines, press Ġ.
To scroll the cursor up seven command lines, press ƒ}.
Inserting and Deleting Command Lines
Inserting and Deleting Command LinesInserting and Deleting Command Lines
Inserting and Deleting Command Lines
To insert a new command line anywhere in the program, place the cursor where you
want the new line, press y6, and then press Í. A colon indicates a new line.
To delete a command line, place the cursor on the line, press ‘ to clear all
instructions and expressions on the line, and then press { to delete the command line,
including the colon.
Copying and Renaming Programs
Copying and Renaming ProgramsCopying and Renaming Programs
Copying and Renaming Programs
Copying and Renaming a Program
Copying and Renaming a ProgramCopying and Renaming a Program
Copying and Renaming a Program
To copy all command lines from one program into a new program, follow steps 1 through
5 for Creating a New Program, and then follow these steps.
1. Press y K.
Rcl is displayed on the bottom line of the program editor in the new
program (Chapter 1).
2. Press  | to display the
PRGM EXEC menu.
3. Select a name from the menu.
prgmname is pasted to the bottom line of the program
editor.
4. Press Í. All command lines from the selected program are copied into the new
program.